| Field Summary |
|
| final public static short | BAD_LENGTH
This reason code is used by the
APDU.setOutgoingLength() method to indicate
that the length parameter is greater that 256 or
if non BLOCK CHAINED data transfer is requested and
len is greater than
(IFSD-2), where IFSD is the Outgoing Block Size. |
| final public static short | BUFFER_BOUNDS
This reason code is used by the APDU.sendBytes()
method to indicate
that the sum of buffer offset parameter and the byte length
parameter exceeds the APDU
buffer size. |
| final public static short | ILLEGAL_USE
This APDUException reason code indicates that the
method should
not be invoked
based on the current state of the APDU. |
| final public static short | IO_ERROR
This reason code indicates that an unrecoverable error occurred in the
I/O transmission layer. |
| final public static short | NO_T0_GETRESPONSE
This reason code indicates that during T=0 protocol, the CAD
did not return a GET RESPONSE
command in response to a <61xx> response status to send
additional data. |
| final public static short | NO_T0_REISSUE
This reason code indicates that during T=0 protocol, the CAD
did not reissue the
same APDU command with the corrected length in response to a
<6Cxx> response status
to request command reissue with the specified length. |
| final public static short | T1_IFD_ABORT
This reason code indicates that during T=1 protocol, the CAD
returned an ABORT S-Block
command and aborted the data transfer. |
